Sampling artifacts from conductive silicone tubing

Sampling artifacts from conductive silicone tubing

TitleSampling artifacts from conductive silicone tubing
Publication TypeJournal Article
Year of Publication2009
AuthorsMichael T Timko, Zhenhong Yu, Jesse H Kroll, John T Jayne, Douglas R Worsnop, Richard C Miake-Lye, Timothy B Onasch, David Liscinsky, Thomas W Kirchstetter, Hugo Destaillats, Amara L Holder, Jared D Smith, Kevin R Wilson
JournalAerosol Science and Technology
Volume43
Issue9
Pagination855-865
Date Published06/03/2009
Abstract

We report evidence that carbon impregnated conductive silicone tubing used in aerosol sampling systems can introduce two types of experimental artifacts: (1) silicon tubing dynamically absorbs carbon dioxide gas, requiring greater than 5 minutes to reach equilibrium and (2) silicone tubing emits organic contaminants containing siloxane that are adsorbed onto particles traveling through it and onto downstream quartz fiber filters. The consequence can be substantial for engine exhaust measurements as both artifacts directly impact calculations of particulate mass-based emission indices. The emission of contaminants from the silicone tubing can result in overestimation of organic particle mass concentrations based on real-time aerosol mass spectrometry and the off-line thermal analysis of quartz filters. The adsorption of siloxane contaminants can affect the surface properties of aerosol particles; we observed a marked reduction in the water-affinity of soot particles passed through conductive silicone tubing. These combined observations suggest that the silicone tubing artifacts may have wide consequence for the aerosol community and the tubing should, therefore, be used with caution. Contamination associated with the use of silicone tubing was observed at ambient temperature and, in some cases, was enhanced by mild heating (<70°C) or pre-exposure to a solvent (methanol). Further evaluation is warranted to quantify systematically how the contamination responds to variations in system temperature, physicochemical particle properties, exposure to solvent, sample contact time, tubing age, and sample flow rates.

URLhttp://www.tandfonline.com/doi/abs/10.1080/02786820902984811#preview
DOI10.1080/02786820902984811