Predicted Efficiency of a Nanofluid-Based Direct Absorption Solar Receiver

Publication Type

Conference Paper

Date Published





Due to its renewable and non-polluting nature solar energy is often used in applications such as electricity generation, thermal heating and chemical processing. The most cost-effective solar heaters are of the “flat-plate” type, but these suffer from relatively low efficiency and outlet temperatures. The present study theoretically investigates the feasibility of using a direct absorption solar receiver (DAR) and compares its performance with that of a typical flat-plate collector. Here a nanofluid—a mixture of water and aluminum nanoparticles—is used as the absorbing medium. A two-dimensional heat transfer analysis was developed in which direct sunlight was incident on a thin flowing film of nanofluid. The effects of absorption and scattering within the nanofluid were accounted for. In order to evaluate the temperature profile and intensity distribution within the nanofluid the energy balance equation and heat transport equation were solved numerically. It was observed that the presence of nanoparticles increases the absorption of incident radiation by more than 9 times over that of pure water. According to the results obtained from this study, under similar operating conditions, the efficiency of a DAR using nanofluid as the working fluid is found to be up to 10% higher (on an absolute basis) than that of a flat-plate collector.


ASME 2007 Energy Sustainability Conference

Year of Publication



Research Areas